ป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relay

ป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relay
ป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relayป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relayป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relayป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relayป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relay
รหัสสินค้า D55
หมวดหมู่ รีเลย์ Relay
ราคา 80.00 บาท
สถานะสินค้า พร้อมส่ง
ลงสินค้า 8 พ.ค. 2566
อัพเดทล่าสุด 12 มิ.ย. 2568
คงเหลือ 4 ชิ้น
จำนวน
ชิ้น
หยิบลงตะกร้า
บัตรประชาชน
บุ๊คแบ๊งค์
คุ้มครองโดย LnwPay

ป้องกันกระแสเกิน 5A Over-Current Detection Sensor Module with 12V Relay

โมดูลป้องกันกระแสไฟเกินตั้งค่าได้
0.3-5A ใช้ไฟเลี้ยง 12V สามารถตั้งระดับกระแสไฟที่ต้องการได้โดยการหมุนปรับ

5A Over-Current Detection Sensor Module AC Current Detector with 12V Relay
5A Over-current protection Sensor module uses current transformer to collect the AC signal to achieve the relay over-current signal output within 0-5A. Relay pull while over-current, relay released while not over-current. Users can use the relay COM, NC, NO three ports to control the external circuit on and off, in order to achieve over-current protection.
 
Specifications:
  • Operating voltage: DC12V;
  • Operating current: <20MA;
  • Operating frequency range: 20Hz ~ 400Hz;
  • Output mode: switch signal output;
  • Maximum detection wire diameter: 5.2mm;
  • Mounting hole: hole diameter is 3mm, hole distance is 52.5mm;
  • Operating environment: -40 ℃ ~ +85 ℃;
  • Current detection resolution can change the parameter of resistance parameters;
  • Output over-current switching signal output;
  • Over-current signal setting critical point adjustable, the current detection range AC0.3A-5A;
  • Board Size: 38 * 44mm
 
Using instructions:
 
  • By setting the potentiometer to set the overcurrent protection point, the clockwise adjustment reduces the detection current.
  • Measured the wire through the current transformer, connect VCC and GND to DC12V power supply;
  • Adjust the potentiometer, when you hear the sound of the relay pull (can be measured with a multimeter COM and NO whether was turned on, if connected to the relay means activated), then reduce or cut off the current flowing  that through the tested wire, if the relay release at this time that over-current protection point has been identified (available to multimeter COM and NC measurement whether is connected, if connected to the relay means been released);
  • When reduce or cut off the current flowing through the wire, the relay is not released, will still need to continue to adjust the potentiometer to find the over-current protection point

วิธีการชำระเงิน

  1. ชำระเงินค่าสินค้าโดยการโอนเงินเข้าบัญชีด้านล่าง โดยลูกค้าสามารถโอนเงินหลังทำรายการสั่งซื้อได้ทันทีไม่ต้องรอยืนยัน

  2. หลังจากโอนเงินแล้วสามารถแจ้งชำระเงินได้ที่ เมนูแจ้งชำระเงิน


หรือชำระเงินผ่าน PayPal โดยคลิกที่ ชำระเงินออนไลน์

ธนาคารกรุงเทพ จำกัด (มหาชน) สาขามหาวิทยาลัยเกษตรศาสตร์ ออมทรัพย์
บมจ. ธนาคารกสิกรไทย สาขามหาวิทยาลัยเกษตรศาสตร์ ออมทรัพย์
ธนาคารไทยพาณิชย์ จำกัด (มหาชน) สาขามหาวิทยาลัยเกษตรศาสตร์ ออมทรัพย์
บมจ. ธนาคารกรุงไทย สาขามหาวิทยาลัยเกษตรศาสตร์ ออมทรัพย์
ธนาคารทหารไทยธนชาต จำกัด (มหาชน) สาขาME BY TMB ออมทรัพย์
พร้อมเพย์ สาขา- -
Scan this!
ดิศรณ์ ตันติเกตุ
098-xxxxxx-2
Accept All Banks | รับเงินได้จากทุกธนาคาร
  • ค่าธรรมเนียม 3.9% + 11 THB
  • การชำระผ่าน PayPal คุณไม่จำเป็นต้องแจ้งชำระเงิน เนื่องจากระบบจะจัดการให้คุณทันที ที่คุณชำระเงินเสร็จสมบูรณ์

ติดตามร้านของเราผ่านแอพได้แล้ววันนี้
  • พิมพ์ “GenLogic” ในช่อง Search
  • หรือเข้าจากรายการร้านค้าโปรดของฉัน

  • ค้นหา
*ใส่ เบอร์มือถือ หรือ email ที่ใช้ในการสั่งซื้อ

เข้าร่วมร้านค้า Arduino4

ร้านGenLogic
ร้านGenLogic
/www.genlogic.co.th/
Join เป็นสมาชิกร้าน
251
สมัครสมาชิกร้านนี้ เพื่อรับสิทธิพิเศษ

สถิติร้าน Arduino4

หน้าที่เข้าชม1,830,165 ครั้ง
ผู้ชมทั้งหมด799,165 ครั้ง
เปิดร้าน12 ธ.ค. 2558
ร้านค้าอัพเดท8 ก.ย. 2568
รายการสั่งซื้อของฉัน
เข้าสู่ระบบด้วย
เข้าสู่ระบบ
สมัครสมาชิก

ยังไม่มีบัญชีเทพ สร้างบัญชีใหม่ ไม่มีค่าใช้จ่าย
สมัครสมาชิก (ฟรี)
รายการสั่งซื้อของฉัน
ข้อมูลร้านค้านี้
ร้านGenLogic
GenLogic
ขายบอร์ด Arduino และอุปกรณ์อื่นๆ ที่ใช้ร่วมกับ Arduino รวมถึง Microcontroller, Module, Breakout board, Sensor และอุปกรณ์อิเล็กทรอนิกส์ต่างๆ ในราคาถูก เหมาะสำหรับผู้ที่สนใจเกี่ยวกับ Arduino และการโปรแกรมระบบ Microcontroller และอิเล็กทรอนิกส์ทั่วไป และทำโปรเจคต่างๆ ร้านมีสินค้าสต็อกพร้อมจัดส่ง จัดส่งสินค้ารวดเร็วภายใน 1-2 วันทำการเท่านั้น
เบอร์โทร :
อีเมล : sale@genlogic.co.th
ส่งข้อความติดต่อร้าน
เกี่ยวกับร้านค้านี้
สินค้าที่ดูล่าสุด
ดูสินค้าทั้งหมดในร้าน
สินค้าที่ดูล่าสุด
บันทึกเป็นร้านโปรด
Join เป็นสมาชิกร้าน
แชร์หน้านี้
แชร์หน้านี้

TOP เลื่อนขึ้นบนสุด
พูดคุย-สอบถาม