FT232RL USB To Serial Adapter Module USB TO 232 Download Cable For Arduino
ตัวแปลงจาก USB เป็น TTL UART สำหรับเบิร์นโปรแกรมตัวบอร์ด Arduino ทุกรุ่นที่ไม่มี USB รวมไปถึง ใช้กับโปรแกรมตัวโมดูล ESP8266 Wifi ได้ สามารถเลือกแรงดันได้ทั้ง 3.3v และ 5v และมี pin สำหรับการเชื่อมต่ออื่นๆ
ใช้สำหรับเบิร์นโปรแกรมลง Arduino รุ่นที่ไม่มี USB เช่น Arduino Pro Mini ใช้งานง่าย มีขา DTR มาให้ด้วย ทำให้เบิร์นได้เลย ไม่ต้องกดปุ่มรีเซต ใช้ชิฟ FT232RL ตัวเดียวกับที่บอร์ด Arduino
คุณสมบัติ FTDI FT232RL USB to TTL Serial Adapter for Arduino
-
Chip: FT232RL
-
Draw out all signal port of FT232RL chip.
-
RXD/TXD transceiver communication indicator.
-
USB power supply, can choose 5V or 3.3V ,set by jumper.
-
Size: 3.2cm x 1.5cm
รายละเอียดเพิ่มเติม FTDI FT232RL USB to TTL Serial Adapter for Arduino
The USB to TTL serial adapter is based on the high quality and very popular FTDI FT232RL chipset and is an excellent way to connect TTL serial devices to a PC through a USB port.
The main connector has 6 pins:
- DTR: Data Terminal Ready - an output used for flow control
- RX: Serial data Receive pin
- TX: Serial data Transmit pin
- VCC: Positive voltage output - this is controlled by the jumper. If the jumper is set to 5V, this will provide a 5V output. If the jumper is set to 3.3V, this will provide a 3.3V output.
- CTS: Clear To Send - an input used for flow control
- GND: Ground or 0V
For most uses, you can simply connect the following pins:
- RX on this board to the TX pin on your device
- TX on this board to the RX pin on your device
- GND on this board to GND on your device
- The VCC pin is ideal for powering small devices such as homemade circuits. This pin should not be connected when a device has a separate power supply as this may damage both devices.
Please note that in 5V mode the maximum current draw on this pin is approximately 500mA. In 3.3V mode the maximum current draw on VCC is approximately 50mA.